Configure Spanning Tree Protocol, 802.1Q Vlan, And Link Layer Discovery Protocol; Configure Stp And Vlans - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Table 29. DHCP server settings for IPv6 (continued)
Setting
Prefix Length
Gateway IPv6 Address
Primary DNS Address
Secondary DNS Address Enter the IP address of the secondary DNS server available to DHCP clients.
Primary WINS Server
Secondary WINS Server
Lease
3. Click Apply to save your settings.
Configure Spanning Tree Protocol, 802.1Q VLAN, and
Link Layer Discovery Protocol
•

Configure STP and VLANs

• Configure Ethernet LLDP
As part of the advanced system configuration, you can enable the Spanning Tree Protocol
(STP), configure the VLANs, and enable Ethernet Link Layer Discovery Protocol (LLDP).
Configure STP and VLANs
STP provides network traffic optimization in locations where multiple wireless access points
are active by preventing path redundancy. NETGEAR recommends that you enable STP if
you have more than one active wireless access point at your location.
The 802.1Q VLAN protocol on the wireless access point logically separates traffic on the
same physical network:
• Untagged VLAN. When the wireless access point sends frames that are associated with
the untagged VLAN from its Ethernet interface, those frames are untagged. When the
wireless access point receives untagged frames over its Ethernet interface, those frames
are assigned to the untagged VLAN.
Description
Enter the prefix length to be used by DHCP clients. The default length is 64.
Enter the IPv6 address of the default routing gateway to be used by DHCP
clients. The default address is 2001:05c0:9168::1.
Enter the IP address of the primary Domain Name System (DNS) server
available to DHCP clients.
Enter the IP address of the primary WINS server for the network, if there is any.
Enter the IP address of the secondary WINS server for the network, if there is
any.
Enter the period that the DHCP server grants to DHCP clients to use the
assigned IP addresses. The default time is one day.
Advanced Configuration
103