Configure The Ipv4 Settings - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Table 3. Time system settings (continued)
Setting
NTP Client
Use Custom NTP Server
3. Click Apply to save your settings.

Configure the IPv4 Settings

Note: For information about how to configure the IPv6 settings, see
Configure the IPv6 Settings
WARNING:
If you enable the DHCP client, the IP address of the wireless
access point changes when you click Apply, causing you to lose
your connection to the wireless access point. You then need to
use the new IP address to reconnect to the wireless access point.
Tip: If you enable the DHCP client on the wireless access point, you can
discover the new IP address of the wireless access point by accessing
the DHCP server on your LAN, or by using a network IP address scanner
application.

To configure the IPv4 settings:
1. Select Configuration > IP > IP Settings. The IP Settings screen displays:
Description
Enable the Network Time Protocol (NTP) client to synchronize the time of the
wireless access point with an NTP server. By default the Enable radio button is
selected.
Select this check box if you want to use a custom NTP server.
Note: You need to have an Internet connection to use an NTP server that is
not on your local network.
Hostname / Enter the host name or IP address of the custom NTP server.
IP Address The default is time-b.netgear.com.
Note: If you use a host name, make sure that you have
configured a DNS server. For more information, see the next
section.
on page 99.
Installation and Basic Configuration
25