Configure The Optional Dhcpv4 Server - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660

Configure the Optional DHCPv4 Server

The wireless access point provides a built-in DHCPv4 server for wireless clients only, which
can be especially useful in small networks. When the DHCP server is enabled, the wireless
access point provides preconfigured TCP/IP configurations to all connected wireless stations.
Note: For information about how to configure the DHCPv6 server, see
Configure the Optional DHCPv6 Server

To configure DHCPv4 server settings:
1. Select Configuration > IP > DHCP Server Settings. The DHCP Server Settings screen
displays. The following figure displays the DHCPv4 server settings only. For information
about the DHCPv6 server settings, see
page 101.
Figure 14.
2. Configure the settings as explained in the following table:
Table 5. DHCP server settings for IPv4
Setting
Select the DHCPv4 Server check box to enable the DHCP server. Use the default settings or specify the
pool of IPv4 addresses to be assigned by setting the starting IPv4 address and ending IPv4 address. These
addresses should be part of the same IPv4 address subnet as the wireless access point's LAN IPv4
address.
DHCP Server VLAN ID
Starting IPv4 Address
Configure the Optional DHCPv6 Server
Description
Enter the VLAN ID for the DHCP server. The VLAN ID range is from 1 to 4094.
The default VLAN is 1.
Enter the first address in the range of IPv4 addresses to be assigned to DHCP
clients. The default address is 192.168.1.02.
Installation and Basic Configuration
27
on page 101.
on