Top Panel - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660

Top Panel

The LEDs of the wireless access point are described in the following figure and table:
Figure 1.
Table 1. Top panel LEDs
Item LED Description
1 Power/Test Off
2 Active
3 LAN 1
4 LAN 2
1 2
On (green)
Amber, then blinking
green
Off
On or blinking (green) Ethernet traffic is detected.
Off
Amber
Green
Off
Amber
Green
Introduction
12
4
3
Power is off.
Power is on.
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LED remains amber or continues to blink green, it
indicates a system fault.
No Ethernet traffic is detected, or no link is detected.
10 Mbps or no link is detected on LAN port 1.
10/100 Mbps link is detected on LAN port 1.
1000 Mbps link is detected on LAN port 1.
10 Mbps or no link is detected on LAN port 2.
10/100 Mbps link is detected on LAN port 2.
1000 Mbps link is detected on LAN port 2.
5
6