Configure Ethernet Lldp - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
2. Specify the settings as explained in the following table:
Table 30. STP and VLAN settings
Setting
Spanning Tree Protocol
Spanning Tree Protocol Select the Enable radio button to enable STP to prevent path redundancy. By
802.1Q VLAN
Untagged VLAN
Management VLAN
WARNING:
Selecting the Untagged VLAN check box or changing the
untagged VLAN value causes loss of IP connectivity if the hubs
and switches on your LAN have not yet been configured with the
corresponding VLAN.
3. Click Apply to save your settings.

Configure Ethernet LLDP

Link Layer Discovery Protocol (LLDP), IEEE 802.1ab, is a management tool that delivers
link-layer messages to adjacent network devices. For example, LLDP messages enable
networking devices such as switches and management tools to discover the wireless access
point in the network, and might indicate whether the wireless access point receives power
through a PoE connection. LLDP is intervendor compatible.
By default, LLDP is enabled on the wireless access point.

To turn off LLDP:
1. Select Configuring > System > Advanced > Ethernet LLDP. The Ethernet LLDP
screen displays:
Description
default, the Disable radio button is selected.
Select the Untagged VLAN check box to configure one VLAN as an untagged
VLAN. By default, the Untagged VLAN check box is selected.
Specify a VLAN ID. The default VLAN ID is 1.
Specify an ID for the VLAN from which the wireless access point can be
managed. The default VLAN ID is 1.
Note: If you configure the management VLAN ID as 0 (zero), the wireless access
point can be managed over any VLAN, and frames that belong to the
management VLAN are not tagged with an 802.1Q header when sent over the
trunk.
Advanced Configuration
105