Mount The Wireless Access Point; Ceiling Installation - NETGEAR ProSafe Premium WNDAP660 Reference Manual

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
NETGEAR recommends that you complete the following tasks before you deploy the
wireless access point in your network:
• Configure wireless security and other wireless features as described in
Wireless Configuration and
• Configure any additional features that you might need as described in
Management and
After you have completed the configuration of the wireless access point, you can reconfigure
the computer that you used for this process back to its original TCP/IP settings.

Mount the Wireless Access Point

•

Ceiling Installation

• Wall Installation
• Desk Installation
Note: NETGEAR recommends that you review the information in
Equipment Placement and Range Guidelines
mount the wireless access point at its permanent position.
Note: The figures in the procedures in this section do not show the
WNDAP660 wireless access point. However, the procedures are
generic and do apply to the WNDAP660 wireless access point.
Ceiling Installation
The best location for ceiling installation is at the center of your wireless coverage area, and
within line of sight of all mobile devices. Make sure the top (the dome side) of the wireless
access point is directed toward the users and not the ceiling.
Security.
Monitoring, and Chapter 5, Advanced
Installation and Basic Configuration
35
Chapter 3,
Chapter 4,
Configuration.
Wireless
on page 17 before you