Fujitsu SPARC Enterprise M4000 Reference Manual page 52

console(8)
EXTENDED
DESCRIPTION
EXIT STATUS
SEE ALSO
34
Automatically answers 'n' (no) to all prompts.
-n
Suppresses all messages to stdout, including prompts.
-q
Sets up a connection to a read-only console.
-r
-s escapeChar Specifies an escape character. The default is '#' (sharp). The
character specified for escapeChar must be enclosed in double
quotation (" "). The following symbols can be specified for
escapeChar:
'#', '@', '^', '&', '?', '*', '=', '.', '|'
Specified escape character is available only in the session that
executed the console(8) command.
Automatically answers 'y' (yes) to all prompts.
-y
When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
The domain console regards '#' used at the beginning of a line as an escape
■
character. An escape character is specified to instruct the console to perform
special processing. Examples of processing that can be specified in combination
with '#' are as follows.
Outputs a status message.
#?
Disconnects the console.
#.
To enter '#' at the beginning of a line, enter '#' twice.
■
To display information on the currently connected domain console, use the
■
showconsolepath(8) command.
The following exit values are returned:
Successful completion.
0
An error occurred.
>0
sendbreak(8), showconsolepath(8)
XSCF Reference Manual • Last Revised June 2007