Fujitsu SPARC Enterprise M4000 Reference Manual page 250

setssh(8)
OPERANDS
EXTENDED
DESCRIPTION
276
-c {enable|disable} Specifies whether to enable the SSH service. One of the
-c genhostkey
-h
-n
-q
-s line
-u user_name
-y
The following operand is supported:
Generates a host public key for SSH2.
genhostkey
When a host public key is created, a prompt to confirm execution of the
■
command with the specified options is displayed. Enter "y" to execute the
command or "n" to cancel the command.
The setssh(8) command can register one user public key at a time.
■
In time of setssh(8) command execution, finish the input of user public key by
■
pressing Enter and then pressing Ctrl+D (EOF).
In case the XSCF unit is duplicated configuration, the setting automatically
■
reflected to the standby XSCF. When there's a defect on the standby XSCF, it
leads to an error and the setting will be reflected to the active XSCF only.
The information which has been set will be reflected by using the
■
rebootxscf(8) command to reset XSCF.
The current SSH service settings can be checked by using the showssh(8)
■
command.
XSCF Reference Manual • Last Revised January 2007
following values can be specified:
Starts the SSH2 service.
enable
Stops the SSH2 service.
disable
Generates a host public key for SSH2.
Displays usage statement. When used with other options
or operands, an error occurs.
Automatically answers 'n' (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Specifies the user public key number to delete. For line,
specify the number which displayed after the showssh
-c pubkey command executed. Should be specified with
"-c delpubkey."
Specifies the user account name to register or delete the
user public key. Should be specified with "-c
addpubkey" or "-c delpubkey." When the -u option
omitted, the user public key of the current login user
account becomes the target.
Automatically answers 'y' (yes) to all prompts.