Fujitsu SPARC Enterprise M4000 Reference Manual page 373

NAME showntp - display the NTP information which currently set for XSCF
SYNOPSIS showntp {-l | -a | address | -s}
showntp -h
DESCRIPTION The showntp(8) command displays the NTP information which currently set for
XSCF.
The showntp(8) command can display the following information:
■
■
■
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-a
-h
-l
-s
The following operand is supported:
OPERANDS
address
EXTENDED The setntp(8) command sets the NTP servers used in the XSCF network.
DESCRIPTION
NTP servers which have been registered to the XSCF network
Status of synchronization with the NTP servers
Stratum value which has been set to XSCF
Displays all the NTP servers currently set for the XSCF network.
Displays usage statement. When used with other options or
operands, an error occurs.
Displays whether synchronization with an NTP server is being
maintained.
Displays the stratum value which has been set to XSCF.
Specifies the IP address of an NTP server to be displayed. A
specified IP address is a set of four integer values delimited by
the period (.). If the -a option is specified, the operand is
ignored. The following address form is accepted:
xxx.xxx.xxx.xxx
where:
xxx
System Administration
An integer from 0–255. Zero suppression can
be used to specify the integer.
showntp(8)
351