setdomainmode(8)
OPTIONS
EXTENDED
DESCRIPTION
174
The following options are supported:
-d domain_id
Specifies the domain ID to be set. domain_id can be 0–23
depending on the system configuration.
Displays usage statement. When used with other options or
-h
operands, an error occurs.
-m function=mode Sets the domain mode and specifies its values. Use function to set
the domain mode. One of the following can be specified:
diag
secure
autoboot
When diag is specified for function, any of the following can be
specified for mode:
Note – This function cannot be specified for the domain which
is powered on.
none
min
max
When secure or autoboot is specified for function, one of the
following can be specified for mode:
on
off
Automatically answers 'n' (no) to all prompts.
-n
Suppresses all messages to stdout, including prompts.
-q
Automatically answers 'y' (yes) to all prompts.
-y
When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
If the Mode switch on the operator panel is set to Service, the settings have the
■
following values regardless of the domain mode settings of the
setdomainmode(8) command:
Diagnostics Level: operates as the setdomainmode(8) command setting
■
Secure Mode, Autoboot: off
■
XSCF Reference Manual • Last Revised June 2007
Specifies the OpenBoot PROM diagnostic
level.
Specifies whether to enable or disable the
host watchdog and suppress break signal
reception.
Specifies whether to enable or disable the
Auto boot function.
No diagnosis is performed.
Sets standard for the diagnostic level.
Sets maximum for the diagnostic level.
Enables specified function.
Disables specified function.