Fujitsu SPARC Enterprise M4000 Reference Manual page 134

reset(8)
OPERANDS
EXTENDED
DESCRIPTION
EXAMPLES
134
The following operand is supported:
level Specifies the level of resetting. One of the following can be
specified. This operand cannot be omitted.
por
request
xir
When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
The showdomainstatus(8) command can be used to check whether the domain
■
has been reset.
If the reset(8) command is executed under either of the following conditions,
■
processing is stopped before the operating system is started:
The Mode switch on the operator panel is set to Service mode
■
The Auto boot function has been disabled by the setdomainmode (8) command
■
Causes a panic in domain ID 0.
EXAMPLE 1
reset -d 0 panic
XSCF>
DomainID to panic:00
y
Continue? [y|n]:
00:Panicked
*Note*
This command only issues the instruction to reset.
The result of the instruction can be checked by the "showlogs power".
Resets the CPU in domain ID 0. Automatically answers 'y' to all prompts.
EXAMPLE 2
reset -y -d 0 xir
XSCF>
DomainID to reset:00
y
Continue? [y|n]:
00:Reset
*Note*
This command only issues the instruction to reset.
The result of the instruction can be checked by the "showlogs power".
Resets domain ID 0. Suppresses prompts, and automatically answers 'y' to all
EXAMPLE 3
prompts.
reset -q -y -d 0 por
XSCF>
XSCF Reference Manual • Last Revised January 2007
Resets the domain system.
Instructs the domain operating system to
generate a panic.
Resets the domain CPU.