Extending / Removing The Server From The Rack; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Basic hardware procedures
4.4 Extending / removing the server from the
rack
I
In most cases maintenance tasks can be performed while the server is
extended from the rack. However, depending on accessibility or security
guidelines, it may make sense to completely remove the server from the
rack cabinet for maintenance purposes.
V
CAUTION!
Use the anti-tilt plate to prevent the rack from tipping when installing
●
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
Be careful not to pinch fingers or clothes when sliding out the server
●
or pushing it back. Failure to do so may cause injury.
For further safety information, please refer to chapter
●
information" on page
4.4.1

Preliminary steps

Ê If applicable, open the rack door as described in section
door" on page
Ê Shut down and power off the server as described in section
the server" on page
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Remove all remaining external cables from the rear connector panel and
expansion cards. For further information, refer to section
indicators" on page
64
41.
61.
61.
"Disconnecting power cords" on page
575.
Upgrade and Maintenance Manual
"Important
"Opening the rack
"Shutting down
63.
"Connectors and
TX140 S1