Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual page 241

If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 117.
Ê After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê After replacing a network controller, reconfigure your network settings in the
operation system according to the original configuration of the replaced
controller (expansion card or onboard).
I
The following note are required for TX140 S1p (PYT14Pxxx for
Japanese market).
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
TX140 S1
92.
"Looking up changed MAC / WWN addresses"
"Updating RAID controller firmware" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
87.
"Connecting the server to the mains" on
110.
116.
238.
"Closing the rack
111.
114.
105.
"Enabling SVOM
"Enabling
"Note on network
120.
241