Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual page 62

Hide thumbs Also See for PRIMERGY TX140 S1:
Table of Contents

Advertisement

Basic hardware procedures
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê In case of Multipath I/O environments, please refer to section
server maintenance in a Multipath I/O environment" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
96.
Figure 8: Power button on the front panel
Ê Shut down the server.
I
If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section
62
"Removing backup and optical disk media" on
"Locating the defective server" on page
Upgrade and Maintenance Manual
"Verifying and
96.
"Note on
97.
TX140 S1
54.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents