Removing A Bbu From The Chassis; Removing The Bbu From The Bbu Holder - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
Ê Remove the fan module as described in section
on page 208.
9.3.5.3

Removing a BBU from the chassis

Ê Remove the BBU module from the chassis as described in section
"Removing a BBU" on page
9.3.5.4

Removing the BBU from the BBU holder

I
There are different BBUs available (see section
page 246).
TX140 S1
61.
54.
61.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
260.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Locating the defective
66.
"Removing the top cover"
"Removing the fan module"
"Preparing the BBU" on
"Opening the rack
"Shutting down the
63.
65.
(tower
267