Preliminary Steps; Removing The Tpm - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

14.3.3.2 Preliminary steps

Before replacing the TPM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
Ê Remove the fan module as described in section
on page 208.

14.3.3.3 Removing the TPM

Ê Remove the TPM board as described in section
on page 443.
Ê Leave the TPM spacer on the system board when removing the defective
TPM board.
TX140 S1
93.
61.
54.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
Upgrade and Maintenance Manual
System board and components
"Disabling BitLocker
"Opening the rack
"Locating the defective
"Shutting down the server" on
66.
"Removing the top cover"
"Removing the fan module"
"Removing the TPM board"
63.
65.
(tower
449