Cabling
Figure 359: Connecting the ODD SATA cable (B)
Ê Reconnect the new ODD SATA cable to system board connector SATA 5 (1).
Ê Run the ODD SATA cable through the cable clamps (see arrows) as shown
(2).
16.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side / top cover as described in section
on page 80
(rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section
"Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
528
"Mounting the side cover" on page 85
Upgrade and Maintenance Manual
"Mounting the top cover"
89.
87.
(tower
TX140 S1