Minimum Startup Configuration - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

17.4

Minimum startup configuration

Field Replaceable Units (FRU)
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Component
System board
CPU with CPU heat sink
1 memory module
Front panel module
Power supply unit
Table 12: Minimum startup configuration - components
Cable
Front panel cable
Power cable
Table 13: Minimum startup configuration - cables
Ê Shut down the server as described in section
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Take the system down to its minimum startup configuration.
TX140 S1
Notes and reference
no TPM, UFM or expansion cards installed
installed in DIMM slot 1A, see section
"Memory sequence" on page 294
without connected front LAN module
Notes and reference
see section
on page 500
see section
page 510
"Disconnecting power cords" on page
Upgrade and Maintenance Manual
"Replacing the front panel cable"
"Replacing the power cable" on
"Shutting down the server" on
Appendix
63.
587