Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Front panel and external connectors

13.1.5 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the fan module as described in section
on page 209.
Ê Close the front cover and reinstall the ID card as described in section
"Mounting the rack front cover" on page 77
front cover" on page 82
Ê Close the side / top cover as described in section
on page 80 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê Verify whether a backup copy of the system board settings has been
successfully transfered to the Chassis ID EPROM as described in section
"Verifying system information backup / restore" on page
Ê Store your server's system information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section
Prom Tool" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
382
(tower server).
"Mounting the side cover" on page 85
92.
119.
Upgrade and Maintenance Manual
"Installing the fan module"
(rack server) or
87.
"Connecting the server to the mains" on
"Using the Chassis ID
110.
116.
"Mounting the
"Mounting the top cover"
(tower
89.
"Closing the rack
104.
"Enabling SVOM
"Enabling
TX140 S1