Removing A 2.5-Inch Hdd / Ssd Module; Installing A 2.5-Inch Hdd / Ssd Module; Concluding Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Ê Locate the defective HDD / SSD module as described in section
diagnostic indicators on the front" on page
Only applicable for removing intact HDD / SSD modules:
Ê Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
7.2.4.3

Removing a 2.5-inch HDD / SSD module

Ê Remove the HDD / SSD module to be replaced from the server as described
in section "Removing a 2.5-inch HDD / SSD module" on page
7.2.4.4

Installing a 2.5-inch HDD / SSD module

Ê Install the new HDD / SSD module into the empty drive bay as described in
section "Installing 2.5-inch HDD / SSD modules" on page
7.2.4.5

Concluding steps

Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section "Installing the HDD bay cover" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
Ê If applicable, close the rack door as described in section
door" on page
172
117.
92.
Upgrade and Maintenance Manual
57.
163.
84.
"Performing a RAID
"Closing the rack
"Local
168.
TX140 S1