Required Tools; Preliminary Steps; Removing The Fbu From The Chassis - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX140 S1:
Table of Contents

Advertisement

Expansion cards and backup units
9.3.6.1

Required tools

Preliminary and concluding steps: tool-less
Installing a FBU: tool-less
9.3.6.2

Preliminary steps

Before replacing a FBU, perform the following steps:
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 67
(rack server) or
server).
Ê Remove the fan module as described in section
on page
208.
9.3.6.3

Removing the FBU from the chassis

Ê Remove the FBU from the chassis as described in section
FBU" on page
272
61.
54.
61.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 71
264.
Upgrade and Maintenance Manual
"Disabling
94.
"Opening the rack
"Locating the defective
"Shutting down the
66.
"Removing the top cover"
"Removing the fan module"
"Removing a
63.
65.
(tower
TX140 S1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents