Setup Menu; Ocp; Service; System - Ricoh DDP184 User Manual

Setup Menu

When you select Setup from the Main Menu, this screen is displayed. Use it to gain
access to the Setup option screens that are described below. See
21 for the complete Setup Menu structure.

OCP

Touch to display the OCP screen. You use this screen to adjust the contrast values for
the OCP display and buzzer volume. The range of contrast is 1 to 16. The factory
default is 10.The range of buzzer volume is 0 to 5. The factory default is 3.

Service

The Service option is password protected. Contact your Authorized Service Technician
for more information.

System

The System option is password protected. Contact your System Administrator if you
need access to these options.
Software Log
Front Engine
Create software log
Rear Engine
Create software log
Network
Front Engine (Do not change)
IP Address - Factory default is 10.0.1.1
Subnet Mask - Factory default is 0.0.0.0.
Gateway Address - Factory default is 0.0.0.0
Boot Method - Factory default is STATIC
HTTP Port - Factory default is 80
Rear Engine (Do not change)
IP Address - Factory default is 10.0.2.1
Subnet Mask - Factory default is 0.0.0.0.
Gateway Address - Factory default is 0.0.0.0
Boot Method - Factory default is STATIC
HTTP Port - Factory default is 80
CAUTION
If you change the Network parameters, the DDP Server will not be able to
communicate with the printers.
2-18 Operator Control Panel
!
OG L
OG L
0 3
0 0
Table 2-4 on page 2-