Ricoh DDP184 User Manual page 68

5. Place the paper into the tray.
6. Adjust the size guide until the gap is less than 1mm, then tighten the Thumb
Screw. (Skip to Step 7 if the Thumb Screw is not installed).
:
NOTE
The paper should be loaded no higher than the Max. level indicator. The
Max. level indicator is located inside the tray.
7. Close the tray.
8. If you set the sensor plate to
making the following selections:
Printer/Paper Source/Paper Size/1/Paper Size
9. Adjust the paper weight. The default paper weight is 20 lb. bond. If necessary,
change the paper weight by making the following selections:
Printer/Paper Source/
10. Select Index, Bond, or g/m
in Step 3, select the paper size from the OCP by
/Paper Weight/1
2
, then use the keypad to input the weight and press
L
OG 0 1
OG L 0 0
Paper Handling 3-9
.