Ricoh DDP184 User Manual page 162

6. To start the replacement process, make the following selections from the OCP:
Setup / Consumable / Front Engine or Rear Engine / Developer Mix /
Supply
The replacement process takes approximately 2 minutes. (Maximum replacement
time is 4
7. Turn the cap back about 160 degrees in the direction shown and remove the
developer bottle.
CAUTION
The Rear Engine cannot perform a toner supply operation with the Top
Cover open. Make sure the Top Cover is closed.
8. Place the duct cap back on the developer duct.
9. Clean any spilled developer from the printer.
10. Close the Front Cover.
:
NOTE
Save the empty developer bottle for use during the next developer exhaust
process.
6-14 Care and Maintenance
½
minutes.)
°
160
!
OG L
OG L
0 1
0 0