Ricoh DDP184 User Manual page 211

3. Remove the 2 screws securing the black plastic cover on the TH assembly.
Sensor Cable
Motor Cable
TH Cable Cover
4. Unplug the 2 connectors, disconnect the cable from the cable clamp located on the
bottom side of the TH assembly, and remove the TH assembly.
5. Press down slightly on the transfer/separation corotron assembly while pulling
forward to remove it.
6. Install the new transfer/separation corotron unit.
7. Reconnect the cables.
8. Reinstall the black plastic cover, securing it in place with the 2 new purple
thumbscrews. (Using the special tool may help secure the thumbscrews.)
9. Gently close the transport deck handle by turning it up (counterclockwise).
!
CAUTION
Ensure cable connectors are secure.
Ensure the tab on the drum assembly fits into the slot on the transfer/
separation as the deck is closed.
Gently close the transport deck to prevent possible CQ defects.
10. Close the front door.
Corotron Unit
Thumbscrew
(79mm)
Thumbscrew
(42.5 mm)
OG L 0 0
Connectors
Special Tool
Care and Maintenance
Brown
Violet
Red
Black
6-63