Ricoh DDP184 User Manual page 140

Message
H Pos Sensor Error
Clean H Pos Sensor E01F
Getting Time xxx.xxx.xxx
HCF Open
Close Tray E023
HCF Top Cover Open
Close Cover E046
Heater Off Mode
Hopper Size Unmatch
Load Paper E090
Input Keycode
Input Station Cover Open
Close Cover E044
Insufficient Disk Space
One Copy Job
Invalid Password
Invalid Time Server Address The specified Time Server is invalid.
Invalid Value
IS Cover Open
Close Cover E044
LED Eraser Not Set
Set Erase Lamp E080
Lifting Tray Name
Loading Fail Network
Loading Network
Low on Front Staples
Low on Rear Staples
Low Toner - Recovery
Load xx E09A
MBT
Load xx E090
Multi Feed Jam HCFx
Remove Paper E15D
or E15E
Description
Image Sensor (H Pos Sensor) is dirty. Clean the Image Sensor.
Getting the time
The door of the high capacity feeder is
open.
Self-explanatory.
Status message
The wrong size paper is loaded in the
hopper.
A valid keycode is required to activate
this feature.
The IS cover is also referred to as the
vertical path cover.
There is not enough space for the
requested operation. Only one copy is
printed.
A valid password is required to access
this area of the OCP.
Incorrect value entered.
Self-explanatory.
The LED eraser is not set.
The specified tray is moving into the
feed position.
Status message.
Status message.
Status message.
Status message.
In process of supplying the toner.
The wrong paper size is loaded in the
multi-bypass tray.
Two sheets were fed from the HCF.
OG L
OG L
Corrective Action
None
Close the door.
Close the cover.
Heater off mode is cancelled when
1. the printer is On Line
2. any OCP key is pushed.
3. the consumable counter is reset
from the Web.
4. printer Status is displayed from the
Web.
Load the requested size.
Contact your System Administrator or
authorized Service Technician.
Close the cover.
Increase disk space or send job
multiple times. See table below
Retry password. If incorrect, contact
your System Administrator.
Check the time server IP address via
the Web Utilities.
Re-enter value.
Close the cover.
Contact your authorized Service
Technician.
Status message. Wait for the printer to
return to a Ready state.
Wait for the printer to return to a Ready
state.
Wait for the printer to return to a Ready
state.
Have replacement staples available.
Have replacement staples available.
Wait for the printer to return to a Ready
state.
Load the MBT with the requested
paper size.
Remove the jammed paper.
0 1
0 0
Troubleshooting 5-13