Figure 8-7: Qos - Add Traffic Priority Rule; Table 8-3: Add Traffic Priority Rule - Parameter Descriptions - AudioCodes MP-20x User Manual

MP-20x Telephone Adapter
Table 8-3: Add Traffic Priority Rule - Parameter Descriptions
Parameter
Source Address
Destination Address
Protocol
QoS Operation
Set Priority
Version 3.0.1

Figure 8-7: QoS - Add Traffic Priority Rule

The source address of the packets sent to or received from the network
object. From the drop-down list choose 'Any', 'User Defined' or the host.
The destination address of the packets sent to or received from the network
object. This address can be configured in the same manner as the source
address. From the drop-down list choose 'Any', 'User Defined' or the host.
From the drop-down list, choose a specific traffic protocol, or add a new
one by choosing 'User Defined'; the screen 'Edit Service' opens. Click the
icon 'new' under the column 'Action'; this commences a sequence that adds
a new protocol.
In this screen section, set a Quality of Service working method. Check
parameter 'Set Priority' or 'Set DSCP' (refer to the descriptions below).
Check this check box to add a priority to the rule; the screen 'Edit Service'
opens, allowing you to select between one of eight priority levels, 0 =
lowest and 7 = highest (each priority level is mapped to low/medium/high
priority). This sets the priority of a packet on the connection matching the
rule, while routing the packet.
Description
79
8. Quality of Service (QoS)
July 2010