Wan Pppoe; General; Figure 10-7: General Pppoe Settings; Table 10-3: Pppoe Parameter Descriptions - AudioCodes MP-20x User Manual

10.2

WAN PPPoE

Point-to-Point Protocol over Ethernet (PPPoE) relies on two widely accepted standards,
PPP and Ethernet. PPPoE enables your home network PCs that communicate on an
Ethernet network to exchange information with PCs on the Internet. PPPoE supports the
protocol layers and authentication widely used in PPP and enables a point-to-point
connection to be established in the normally multipoint architecture of Ethernet.
A discovery process in PPPoE determines the Ethernet MAC address of the remote device
in order to establish a session.

10.2.1 General

Parameter
Schedule You can configure scheduler rules in order to define time segments during
which the connection is active (via Advanced>Scheduler Rules).
Network Select whether the parameters you are configuring relate to a LAN/WAN
connection, by selecting LAN/WAN from the drop down list.
MTU MTU is the Maximum Transmission Unit. It specifies the largest packet size
permitted for Internet transmission. The default setting, Manual, allows you to
enter the largest packet size for transmitting. The recommended size is 1492.
You should leave this value in the 1200 to 1500 range. To have the Telephone
Adapter select the best MTU for your Internet connection, select Automatic.
Underlying Specify the underlying connection above which the protocol is initiated.
Connection
MP-20x Telephone Adapter

Table 10-3: PPPoE Parameter Descriptions

Figure 10-7: General PPPoE Settings

110
Description
Document #: LTRT-50609
User's Manual