Figure 11-8: Add Traffic Priority Rule Screen - AudioCodes MP-20 Series User Manual

User's Manual
After clicking the appropriate New Entry link, the 'Add Traffic Priority Rule' screen
2.
appears.
3. Under the Matching group, configure the matching characteristics:
a. From the 'Source Address' drop-down list, select 'Any', 'User Defined' or the host
as the source address of the packets sent to or received from the network object.
If you have created network objects (see Section
are also displayed in the list (or you can create one by selecting 'User Defined').
b. From the 'Destination Address' drop-down list, select the network object for the
destination address of the packets sent to or received from the network object.
See Step 3 above for a detailed explanation on the options.
c. From the 'Protocol' drop-down list, select the protocol. You can apply the rule to
all protocols (i.e., 'Any') or select an already defined protocol. You can create a
new protocol by selecting 'User Defined', and then following the procedure
described in Section
d. To match DSCP, select the 'DSCP' check box, and then enter the DSCP
markings.
e. To match priority, select the 'Priority' check box, and then select the priority of the
packets.
f. To match the Device, select the 'Device' check box, and then select the Device
interface.
Version 4.4.3

Figure 11-8: Add Traffic Priority Rule Screen

5.6.3 on page 59.
125
11. Quality of Service
5.6.2 on page 57), then these
MP-20x Multimedia Home Gateway