Troubleshooting for Outdoor Unit
6.8
Compressor Lock
E6
Remote
Controller
Display
Outdoor Unit LED
A
5
Display
Method of
A compressor lock is detected by checking the compressor running condition through the position
Malfunction
detection circuit.
Detection
Judging from the current waveform generated when high-frequency voltage is applied to the
Malfunction
Decision
If the error repeats, the system is shut down.
Conditions
Reset condition: Continuous run for about 5 minutes without any other error
Compressor locked
Supposed
Causes
Troubleshooting
Check No.15
Refer to P.196
167
1
3
2
4
3
4
4
3
compressor.
Be sure to turn off the power switch before connecting or disconnecting
Caution
connectors, or parts may be damaged.
(Precaution before turning on the power again)
Make sure the power has been off for at least 30 seconds.
Turn off the power. Disconnect the
harnesses U, V, and W.
Check No.15
Check with the inverter checker (∗).
Normal?
YES
Turn off the power and reconnect
the harnesses. Turn on the power
again and restart the system.
Emergency
stop without compressor
running?
NO
System shut
down after errors repeated
several times?
YES
∗ Inverter checker
Part No.: 1225477
NO
YES
NO
SiUS12-928_B
Correct the power supply or
replace the outdoor unit
PCB.
Replace the compressor.
Check the outdoor electronic
expansion valve coil.
Replace it as required.
Replace the compressor.
(R14439)
Service Diagnosis