Load Factory Default; Save Configuration - ZyXEL Communications MGS-3712F User Manual

Chapter 33 Maintenance
Table 99 Management > Maintenance (continued)
LABEL
Load
Factory
Default
Save
Configuratio
n
Reboot
System

33.2 Load Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
In the Maintenance screen, click the Click Here button next to Load Factory
1
Default to clear all Switch configuration information you configured and return to
the factory defaults.
Click OK to reset all Switch configurations to the factory defaults.
2
Figure 164 Load Factory Default: Start
In the web configurator, click the Save button in the top of the screen to make the
3
changes take effect. If you want to access the Switch web configurator again, you
may need to change the IP address of your computer to be in the same subnet as
that of the default Switch IP address (192.168.1.1).

33.3 Save Configuration

Click Config 1 to save the current configuration settings permanently to
Configuration 1 on the Switch.
298
DESCRIPTION
Click Click Here to reset the configuration to the factory default settings.
Click Config 1 to save the current configuration settings to Configuration
1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration
2 on the Switch.
Click Config 1 to reboot the system and load Configuration 1 on the
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the
Switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the Switch.
MGS-3712/MGS-3712F User's Guide