Load Factory Default; Save Configuration - ZyXEL Communications GS1920-24 User Manual

Management > Maintenance (continued)
Table 148
LABEL
Restore
Configuration
Backup
Configuration
Load Factory
Default
Save
Configuration
Reboot System
Tech Support
37.2.1

Load Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all
1
Switch configuration information you configured and return to the factory defaults.
Click OK to reset all Switch configurations to the factory defaults.
2
Figure 220
In the web configurator, click the Save button in the top of the screen to make the changes take
3
effect. If you want to access the Switch web configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address
(192.168.1.1).
37.2.2

Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the
Switch.
Chapter 37 Maintenance
DESCRIPTION
Click Click Here to go to the Restore Configuration screen.
Click Click Here to go to the Backup Configuration screen.
Click Click Here to reset the configuration to the factory default settings.
Click Config 1 to save the current configuration settings to Configuration 1 on the
Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the
Switch.
Click Config 1 to reboot the system and load Configuration 1 on the Switch.
Click Config 2 to reboot the system and load Configuration 2 on the Switch.
Note: Make sure to click the Save button in any screen to save your settings to the current
configuration on the Switch.
Click Click Here to see the Tech-Support screen. You can set CPU and memory thresholds
for log reports and download related log reports for issue analysis. Log reports include CPU
history and utilization, crash and memory.
Load Factory Default: Start
GS1920 Series User's Guide
300