Configure Rapid Spanning Tree Protocol - ZyXEL Communications MGS-3712F User Manual

13.4 Configure Rapid Spanning Tree Protocol

Use this screen to configure RSTP settings, see
information on RSTP. Click RSTP in the Advanced Application > Spanning
Tree Protocol screen.
Figure 73 Advanced Application > Spanning Tree Protocol > RSTP
The following table describes the labels in this screen.
Table 27 Advanced Application > Spanning Tree Protocol > RSTP
LABEL
Status
Active
MGS-3712/MGS-3712F User's Guide
DESCRIPTION
Click Status to display the RSTP Status screen (see
135).
Select this check box to activate RSTP. Clear this checkbox to disable
RSTP.
Note: You must also activate Rapid Spanning Tree in the
Advanced Application > Spanning Tree Protocol >
Configuration screen to enable RSTP on the Switch.
Chapter 13 Spanning Tree Protocol
Section 13.1 on page 125
Figure 74 on page
for more
133