Viewing And Editing Classifier Configuration - ZyXEL Communications MGS-3712F User Manual

Chapter 20 Classifier
Table 45 Advanced Application > Classifier (continued)
LABEL
Socket
Number
Destination
IP
Address/
Address
Prefix
Socket
Number
Add
Cancel
Clear
20.3 Viewing and Editing Classifier
Configuration
To view a summary of the classifier configuration, scroll down to the summary
table at the bottom of the Classifier screen. To change the settings of a rule, click
a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over
lower layer rule.
Figure 95 Advanced Application > Classifier: Summary Table
180
DESCRIPTION
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to
49 on page 182 for more information.
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to
49 on page 182 for more information.
Click Add to insert the entry in the summary table below and save your
changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields back to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
MGS-3712/MGS-3712F User's Guide
Table
Table