ZyXEL Communications MGS-3712F User Manual page 89

Table 11 Basic Setting > IP Setup (continued)
LABEL
Default
Management
In-Band Management IP Address
DHCP Client
Static IP Address
IP Address
IP Subnet Mask
Default Gateway
VID
Out-of-band Management IP Address
IP Address
Subnet Mask
Default Gateway
Apply
Cancel
MGS-3712/MGS-3712F User's Guide
DESCRIPTION
Specify which traffic flow (In-Band or Out-of-band) the Switch is to
send packets originating from itself (such as SNMP traps) or packets
with unknown source.
Select Out-of-band to have the Switch send the packets to the out-
of-band management port. This means that device(s) connected to
the other port(s) do not receive these packets.
Select In-Band to have the Switch send the packets to all ports
except the out-of-band management port to which connected
device(s) do not receive these packets.
Select this option if you have a DHCP server that can assign the
Switch an IP address, subnet mask, a default gateway IP address and
a domain name server IP address automatically.
Select this option if you don't have a DHCP server or if you wish to
assign static IP address information to the Switch. You need to fill in
the following fields when you select this option.
Enter the IP address of your Switch in dotted decimal notation for
example 192.168.1.1.
Enter the IP subnet mask of your Switch in dotted decimal notation
for example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted
decimal notation, for example 192.168.1.254.
Enter the VLAN identification number associated with the Switch IP
address. This is the VLAN ID of the CPU and is used for management
only. The default is "1". All ports, by default, are fixed members of
this "management VLAN" in order to manage the device from any
port. If a port is not a member of this VLAN, then users on that port
cannot access the device. To access the Switch make sure the port
that you are connected to is a member of Management VLAN.
Enter the IP address of your Switch in dotted decimal notation for
example 192.168.0.1.
If you change this IP address, make sure the computer connected to
this management port is in the same subnet before accessing the
Switch.
Enter the IP subnet mask of your Switch in dotted decimal notation
for example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted
decimal notation, for example 192.168.0.254.
Click Apply to save your changes to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the fields again.
Chapter 8 Basic Setting
89