Configuring Static Routing - ZyXEL Communications MGS-3712F User Manual

Chapter 30 Static Route

30.2 Configuring Static Routing

Click IP Application > Static Routing in the navigation panel to display the
screen as shown.
Figure 148 IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 90 IP Application > Static Routing
LABEL
Active
Name
Destination
IP Address
IP Subnet
Mask
Gateway IP
Address
Metric
Add
Cancel
Clear
276
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for
identification purposes.
This parameter specifies the IP network address of the final destination.
Enter the subnet mask for this destination. Routing is always based on
network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your Switch that will forward the packet to the destination.
The gateway must be a router on the same segment as your Switch.
The metric represents the "cost" of transmission for routing purposes. IP
routing uses hop count as the measurement of cost, with a minimum of 1
for directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be between
1 and 15. In practice, 2 or 3 is usually a good number.
Click Add to insert a new static route to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to reset the above fields to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
MGS-3712/MGS-3712F User's Guide