Configuring Vlan Mapping - ZyXEL Communications MGS-3712F User Manual

28.3 Configuring VLAN Mapping

Click the VLAN Mapping Configure link in the VLAN Mapping screen to display
the screen as shown. Use this screen to enable and edit the VLAN mapping
rule(s).
Figure 143 VLAN Mapping Configuration
The following table describes the labels in this screen.
Table 88 VLAN Mapping Configuration
LABEL
Active
Name
Port
VID
Translated VID Enter a VLAN ID (from 1 to 4094) into which the customer VID carried in
Priority
Add
Cancel
Index
MGS-3712/MGS-3712F User's Guide
DESCRIPTION
Check this box to activate this rule.
Enter a descriptive name (up to 32 printable ASCII characters) for
identification purposes.
Type a port to be included in this rule.
Enter a VLAN ID from 1 to 4094. This is the VLAN tag carried in the
packets and will be translated into the VID you specified in the
Translated VID field.
the packets will be translated.
Select a priority level (from 0 to 7). This is the priority level that replaces
the customer priority level in the tagged packets or adds to the untagged
packets.
Click Add to insert the entry in the summary table below and save your
changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to reset the fields to your previous configuration.
This is the number of the VLAN mapping entry in the table.
Chapter 28 VLAN Mapping
267