ZyXEL Communications MGS-3712F User Manual page 61

Table 5 Navigation Panel Links (continued)
LINK
VLAN Stacking
Multicast
AAA
IP Source
Guard
Loop Guard
VLAN Mapping
Layer 2
Protocol
Tunneling
IP Application
Static Routing
DiffServ
DHCP
Management
Maintenance
Access Control
Diagnostic
Syslog
Cluster
Management
MAC Table
ARP Table
Configure
Clone
MGS-3712/MGS-3712F User's Guide
DESCRIPTION
This link takes you to screens where you can configure VLAN stacking
which helps to distinguish multiple customers VLANs.
This link takes you to screens where you can configure various multicast
features, IGMP snooping and create multicast VLANs.
This link takes you to a screen where you can configure authentication,
authorization and accounting services via external servers. The external
servers can be either RADIUS (Remote Authentication Dial-In User
Service) or TACACS+ (Terminal Access Controller Access-Control System
Plus).
This link takes you to screens where you can configure filtering of
unauthorized DHCP and ARP packets in your network.
This link takes you to a screen where you can configure protection
against network loops that occur on the edge of your network.
This link takes you to screens where you can configure VLAN mapping
settings on the Switch.
This link takes you to a screen where you can configure L2PT (Layer 2
Protocol Tunneling) settings on the Switch.
This link takes you to a screen where you can configure static routes. A
static route defines how the Switch should forward traffic by configuring
the TCP/IP parameters manually.
This link takes you to screens where you can enable DiffServ, configure
Two Rate Three Color Marker settings and set DSCP-to-IEEE802.1p
mappings.
This link takes you to screens where you can configure the DHCP
settings.
This link takes you to screens where you can perform firmware and
configuration file maintenance as well as reboot the system.
This link takes you to screens where you can change the system login
password and configure SNMP and remote management.
This link takes you to a screen where you can view system logs and test
port(s).
This link takes you to screens where you can setup system logs and a
system log server.
This link takes you to screens where you can configure clustering
management and view its status.
This link takes you to a screen where you can view the MAC addresses
(and types) of devices attached to what ports and VLAN IDs.
This link takes you to a screen where you can view the MAC addresses –
IP address resolution table.
This link takes you to a screen where you can copy attributes of one port
to other ports.
Chapter 5 The Web Configurator
61