Rapid Spanning Tree Protocol Status - ZyXEL Communications MGS-3712F User Manual

Table 27 Advanced Application > Spanning Tree Protocol > RSTP (continued)
LABEL
Apply
Cancel

13.5 Rapid Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel
to display the status screen as shown next. See
more information on RSTP.
Note: This screen is only available after you activate RSTP on the Switch.
Figure 74 Advanced Application > Spanning Tree Protocol > Status: RSTP
The following table describes the labels in this screen.
Table 28 Advanced Application > Spanning Tree Protocol > Status: RSTP
LABEL
Configuration
Bridge
Bridge ID
Hello Time
(second)
MGS-3712/MGS-3712F User's Guide
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click Configuration to specify which STP mode you want to activate.
Click RSTP to edit RSTP settings on the Switch.
Root refers to the base of the spanning tree (the root bridge). Our
Bridge is this switch. This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority
plus MAC address. This ID is the same for Root and Our Bridge if the
Switch is the root switch.
This is the time interval (in seconds) at which the root switch transmits
a configuration message. The root bridge determines Hello Time, Max
Age and Forwarding Delay.
Chapter 13 Spanning Tree Protocol
Section 13.1 on page 125 for
135