Table of Contents
Advertisement
Line Interfaces
To establish your line interfaces for the four LI1 through LI4 interfaces, click on Line Interfaces. The Current
Setup section reflects the current operating parameters for the indicated Line Interface.
1. Click on the Line Type down arrow and select your type of line interface; T1 RBS or T1 PRI for North
America or E1 PRI for the rest of the world, then wait for the screen to refresh.
2. Use the various pull down menus to match the parameters of the Line Interface with the line provisioning
information from your Telco.
A common provisioning issue is the type of framing format which the telco usually refers to as ESF.
Note:
But, the MultiAccess gives you a choice of ESF or ESF with error correction. Multi-Tech recommends that
you choose ESF with Error Correction.
3. Click Save and the send button will become active.
4. Click the Send button to cause the new parameters to become active. You must wait 45 seconds for the
screen to refresh and the new configuration to apply, then Current Setup section is updated.
MultiAccess Communications Server MA30120 User Guide
Chapter 2 – Installation
20
Advertisement
Table of Contents
