Table of Contents
Advertisement
Chapter 3 – Software
Modem Setup > Fax Setup
be "fax##########.tif" were ###...is equal to the numeric value of the total number of faxes received by the
Hylafax server. The sender of the email ("From" header) will be identified as "The HylaFax Receive Agent".
The subject of the email will identify who sent the facsimile, "Facsimile Received From CSID", if the CSID is
provided by the remote fax location. The body of the email will include the following details about the attached
fax; sender's CSID, number of pages, resolution quality, time and date it was receieved, time to receive, signal
rate, data/compression format, ECM mode and the local identifier.
General Fax Setup
Username & Password
The Username and Password windows are used to create a database of fax client credentials. Install the fax
client on each workstaion you wish to send faxes from. The fax client must use credentials defined here to log
into the Hylafax™ server before submitting faxes for sending. All Fax Clients can use the same set of
credentials, or you may add a set of credentials per client. The fax client uses FTP on TCP port 4559 to submit
faxes to the Hylafax™ server. The Fax Client is not used for receiving faxes.
Fax Modem Setup
The Fax Modem Setup fields are used to configure the fax station identity and other administrative variables.
The default settings are normally sufficient with the exception of the "Rings Before Answer" parameter. When
the Called Number feature is used, the Rings Before Answer must be set to 2 for all the ports. Each Fax
Modem is to be configured with a unique Local Identifier, which is used as the TSI (Transmit Station Identifier)
when sending faxes and is included in the body of the email when receiving faxes. You can limit the maximum
number of pages being received.
Fax Modem
The Fax Modem scroll box allows you to high light a range of modem ports for assigning global parameters or
high lighting individual ports for port specific parameters.
Local Identifier
The Local Identifier is included in the message body of the email. The default identifier is the tty port name.
Max Receive Pages
The default value is 25 pages. Limiting the number of pages is discretionary.
Rings Before Answer
Rings Before Answer option is for incoming faxes. The default value is 1. If the Route By Called Number option
is enabled, the Rings Before Answer must be set to 2.
Fax Delivery Setup
The Fax Delivery Setup section defines how incoming faxes are routed to recipient; by device, by called
number, or route to default, if undetermined. The Fax Delivery options are established by activating an option,
entering an email address, defining a port for the Route by Device option, or entering a Called Number which is
defined by your service provider.
Route by Device
This fax delivery setup allows all incoming faxes on a particular port to be delivered to a specific email address.
When this option is selected, an email address is entered in the Email window and the port is defined by
highlighting a Fax Modem. When the Add button is clicked, the MultiAccess updates the software and then the
entry is shown in the listing at the bottom of the screen. For example, click on Route by Device option, enter
jomalley@multitech.com in the Email window, and for this example I highlighted ttyMA02 as the modem port.
So now, any fax that comes on ttyMA02 is going to be sent to Jomalley@multitech.com.
MultiAccess Communications Server MA30120 User Guide
96
Advertisement
Table of Contents
