Table of Contents
Advertisement
Regulatory Compliance
FCC Part 15 Regulation
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
Warning:
the user's authority to operate the equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada.
FCC Part 68 Telecom
1.
This equipment complies with Part 68 of the Federal Communications Commission (FCC) rules. On the outside surface
of this equipment is a label that contains, among other information, the FCC registration number. This information must
be provided to the telephone company.
2.
As indicated below, the suitable jack (Universal Service Order Code connecting arrangement) for this equipment is
shown. If applicable, the facility interface codes (FIC) and service order codes (SOC) are shown.
3.
An FCC-compliant telephone cord with modular plug is provided with this equipment. This equipment is designed to be
connected to the phone network or premises wiring using a compatible modular jack which is Part 68 compliant. See
installation instructions for details.
4.
The ringer equivalence number (REN) is used to determine the number of devices that may be connected to the phone
line. Excessive REN's on the phone line may result in the device not ringing in response to an incoming call. In most,
but not all areas, the sum of the REN's should not exceed (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total REN's, contact the local phone company.
5.
If this equipment causes harm to the phone network, the phone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn't practical, the phone company will notify the
customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is
necessary.
6.
The phone company may make changes in its facilities, equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the phone company will provide advance notice in order for you to make
necessary modifications in order to maintain uninterrupted service.
7.
If trouble is experienced with this equipment (the model of which is indicated below) please contact Multi-Tech
Systems, Inc., at the address shown below for details of how to have repairs made. If the equipment is causing harm to
the network, the phone company may request that you remove the equipment from the network until the problem is
resolved.
8.
No repairs are to be made by you. Repairs are to be made only by Multi-Tech Systems or its licensees. Unauthorized
repairs void registration and warranty.
9.
This equipment should not be used on party lines or coin lines.
10. Manufacturer and device information:
Manufacturer:
Trade name:
Model Numbers:
FCC Registration Number:
Ringer Equivalence:
Modular Jack:
Service Center in U.S.A.:
MultiAccess Communications Server MA30120 User Guide
Multi-Tech Systems, Inc.
MultiAccess ™
MultiAccess
US: AU7DDNAMA2496
0.3B
RJ-11C or RJ-11W
Multi-Tech Systems Inc.
2205 Woodale Drive
Mounds View, MN 55112
(763) 785-3500 Fax (763) 785-9874
Chapter 6 – Warranty and Service
133
Advertisement
Table of Contents
