Display Multicast Routing-Table Static - HP 6125XLG Command Reference Manual

Related commands
reset multicast routing-table

display multicast routing-table static

Use display multicast routing-table static to display static multicast routing entries.
Syntax
display multicast routing-table static [ source-address { mask-length | mask } ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
source-address: Specifies a multicast source address.
mask-length: Specifies the address mask length, in the range of 0 to 32.
mask: Specifies the mask.
Usage guidelines
This command displays information about only valid static multicast routes.
Examples
# Display information about static multicast routing entries.
<Sysname> display multicast routing-table static
Destinations : 3
Destination/Mask
1.1.0.0/16
2.2.2.0/24
3.3.3.3/32
Table 14 Command output
Field
Destinations
Routes
Destination/Mask
Pre
RPF Neighbor
Interface
Routes : 4
Pre RPF Neighbor
10 7.12.0.1
7.11.0.1
20 7.11.0.1
50 7.12.0.1
Description
Number of the multicast destination addresses.
Number of routes.
Destination address and mask length.
Route preference.
IP address of the RPF neighbor to the reachable destination.
Outgoing interface to the reachable destination.
Interface
Vlan12
Vlan11
Vlan11
Vlan12
35