Ipv6 Pim Timer Join-Prune; Ipv6 Pim Triggered-Hello-Delay; Jp-Pkt-Size (Ipv6 Pim View) - HP 6125XLG Command Reference Manual

Usage guidelines
You can set the interval for sending the join/prune messages in IPv6 PIM view or interface view. The
configurations made in IPv6 PIM view are effective on all interfaces, and the configurations made in
interface view are effective on only the current interface. If you set the interval in both IPv6 PIM view and
interface view, the configuration in interface view always takes precedence.
Examples
# Set the interval for sending the join/prune messages to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim timer join-prune 80
Related commands
timer join-prune (IPv6 PIM view)

ipv6 pim triggered-hello-delay

Use ipv6 pim triggered-hello-delay to set the maximum delay between two hello messages.
Use undo ipv6 pim triggered-hello-delay to restore the default.
Syntax
ipv6 pim triggered-hello-delay delay
undo ipv6 pim triggered-hello-delay
Default
The maximum delay between two hello messages is 5 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
delay: Sets the maximum delay (in seconds) between two hello messages, in the range of 1 to 60.
Examples
# Set the maximum delay between two hello messages to 3 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim triggered-hello-delay 3

jp-pkt-size (IPv6 PIM view)

Use jp-pkt-size to set the maximum size of each join/prune message.
Use undo jp-pkt-size to restore the default.
Syntax
jp-pkt-size size
176