Mld-Snooping Last-Listener-Query-Interval - HP 6125XLG Command Reference Manual

Parameters
interval: Sets an aging timer (in seconds) for the dynamic member ports in a VLAN., in the range of 200
to 1000.
Usage guidelines
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The configuration made in VLAN view is only effective on the current VLAN and takes preference over the
global configuration.
Examples
# Enable MLD snooping for VLAN 2 and set the aging timer for the dynamic member ports in the VLAN
to 300 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping host-aging-time 300
Related commands
host-aging-time (MLD-snooping view)
•
mld-snooping enable
•

mld-snooping last-listener-query-interval

Use mld-snooping last-listener-query-interval to set the MLD last-listener query interval for a VLAN.
Use undo mld-snooping last-listener-query-interval to restore the default.
Syntax
mld-snooping last-listener-query-interval interval
undo mld-snooping last-listener-query-interval
Default
The default setting is 1 second.
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval: Sets the MLD last-listener query interval (in seconds), in the range of 1 to 5.
Usage guidelines
The MLD last-listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response delay for MLD multicast-address-specific queries in a VLAN.
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
113