State-Refresh-Rate-Limit (Pim View); Static-Rp (Pim View) - HP 6125XLG Command Reference Manual

Predefined user roles
network-admin
Parameters
ttl-value: Specifies a TTL value of state refresh messages, in the range of 1 to 255.
Examples
# Set the TTL value of state refresh messages to be 45.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-ttl 45
Related commands
pim state-refresh-capable (PIM view)
•
• state-refresh-interval (PIM view)

state-refresh-rate-limit (PIM view)

•

static-rp (PIM view)

Use static-rp to configure a static RP.
Use undo static-rp to remove a static RP.
Syntax
static-rp rp-address [ acl-number | preferred ] *
undo static-rp rp-address
Default
No static RP is configured.
Views
PIM view
Predefined user roles
network-admin
Parameters
rp-address: Specifies the IP address of the static RP. This address must be a real, valid unicast IP address,
rather than an address on the 127.0.0.0/8 subnet.
acl-number: Specifies an IPv4 basic ACL in the range of 2000 to 2999 to filter IPv4 multicast groups. The
static RP is designated only to IPv4 multicast groups that pass the ACL filtering. If you do not specify an
ACL, or if you specify an ACL that does not exist or does not contain any valid rules, the static RP is
designated to all multicast groups 224.0.0.0/4.
preferred: Gives priority to the static RP if the static RP and the dynamic RP exist at the same time in the
network. The dynamic RP takes effect only if no static RP exists in the network. If this keyword is not
specified, the dynamic RP has priority, and the static RP takes effect only if no dynamic RP exists in the
network or when the dynamic RP fails.
Usage guidelines
You do not need to enable PIM on an interface that acts as a static RP.
92