Crp-Policy (Ipv6 Pim View) - HP 6125XLG Command Reference Manual

Usage guidelines
The IPv6 address of a C-RP must be the IPv6 address of a local IPv6 PIM enabled interface on the C-RP.
Otherwise, the configuration does not take effect.
In an ACL, the source field specifies the IPv6 multicast group range to which the C-RP is designated, and
the other fields are ignored. If the specified IPv6 addresses are not IPv6 multicast addresses, the ACL is
not valid. Only groups that match a permit statement in the ACL are advertised.
To use a C-RP for multiple IPv6 multicast group ranges, you can specify them by multiple permit
statements in an ACL and reference the ACL in the group-policy keyword.
If you execute this command using the same IPv6 address of a C-RP multiple times, the most recent
configuration takes effect.
Examples
# Configure the interface with the IPv6 address of 2001::1 as the C-RP for IPv6 multicast group range
FF0E:0:1391::/96, and set its priority to 10.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff0e:0:1391:: 96
[Sysname-acl6-basic-2000] quit
[Sysname] ipv6 pim
[Sysname-pim6] c-rp 2001::1 group-policy 2000 priority 10

crp-policy (IPv6 PIM view)

Use crp-policy to configure the legal C-RP address range and the IPv6 multicast group range to which the
C-RP is designated.
Use undo crp-policy to remove the configuration.
Syntax
crp-policy acl6-number
undo crp-policy
Default
No restrictions are defined for the legal C-RP address range and the IPv6 multicast group range, and all
received C-RP messages are regarded as legal.
Views
IPv6 PIM view
Predefined user roles
network-admin
Parameters
acl6-number: Specifies an IPv6 advanced ACL, in the range of 3000 to 3999.
Usage guidelines
This command guards against C-RP spoofing.
In an ACL, the source field specifies the legal C-RP IPv6 address range, and the destination field specifies
the IPv6 multicast group range to which the C-RP is designated. If you specify a VPN instance in the ACL,
147