HP 6125XLG Command Reference Manual page 66

Syntax
display pim claimed-route [ source-address ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
source-address: Specifies a multicast source by its IP address. If no multicast source is specified, this
command displays information about all routes that PIM uses.
Examples
# Display information about all routes that PIM uses.
<Sysname> display pim claimed-route
RPF-route selecting rule: longest-match
Route/mask: 7.11.0.0/16 (unicast (direct))
RPF interface: Vlan-interface2, RPF neighbor: 8.0.0.2
Total number of (S,G) or (*,G) dependent on this route entry: 4
(7.11.0.10, 225.1.1.1)
(7.11.0.10, 226.1.1.1)
(7.11.0.10, 227.1.1.1)
(*, 228.1.1.1)
Route/mask: 7.12.0.0/16 (multicast static)
RPF interface: Vlan-interface2, RPF neighbor: 8.0.0.3,
Config NextHop: 8.0.0.5
Total number of (S,G) or (*,G) dependent on this route entry: 2
(7.12.0.10, 226.1.1.1)
(7.12.0.10, 225.1.1.1)
Table 19 Command output
Field
Route/mask
RPF interface
RPF neighbor
Config NextHop
Total number of (S,G) or (*,G) dependent on
this route entry
Description
Route entry. Route types in parentheses include:
•
igp—IGP unicast route.
•
egp—EGP unicast route.
•
unicast (direct)—Direct unicast route.
•
unicast—Other unicast route, such as static unicast route.
•
multicast static—Static multicast route.
Name of the RPF interface.
IP address of the RPF neighbor.
Address of the configured next hop. This field is displayed only
when the static multicast route is configured with a next hop.
Total number (S, G) or (*, G) entries dependent on the RPF
route and their details.
60