Default
IPv6 multicast source port filtering is disabled, and the port can connect to both IPv6 multicast sources
and IPv6 multicast receivers.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
This configuration is only effective on the current port, and has the same configuration priority as the
global configuration.
Examples
# Enable source port filtering for IPv6 multicast data on Ten-GigabitEthernet 1/1/5.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] mld-snooping source-deny
Related commands
source-deny (MLD-snooping view)
mld-snooping static-group
Use mld-snooping static-group to configure a port as a static member port of the specified IPv6 multicast
group or the specified IPv6 multicast source and group.
Use undo mld-snooping static-group to restore the default.
Syntax
mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
undo mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] { all | vlan
vlan-id }
Default
A port is not a static member port of any IPv6 multicast group or IPv6 multicast source and group.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
ipv6-group-address: Specifies an IPv6 multicast group by its IPv6 address. The value can be 0::0 or in the
range of FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where "x" and "y"
represent any hexadecimal number from 0 to F.
ipv6-source-address: Specifies an IPv6 multicast source by its IPv6 address.
all: Specifies all VLANs.
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is 1 to 4094.
117