Table of Contents
Advertisement
5.4 Enable and Configure Wireless Security without WPS
on your NBG-418N v2
This example shows you how to configure wireless security settings with the following parameters
on your NBG-418N v2.
SSID
Channel
Security
Follow the steps below to configure the wireless settings on your NBG-418N v2.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Open the Wireless LAN > General screen in the NBG-418N v2's Web Configurator.
1
Make sure the Enable Wireless LAN check box is selected.
2
Enter SSID_Example3 as the SSID and select a channel.
3
Set security mode to WPA-PSK(AES) and enter ThisismyWPA-PSKpre-sharedkey in the Pre-
4
Shared Key field. Click Apply.
Figure 33 Tutorial: Network > Wireless LAN > General
Open the Status screen. Verify your wireless and wireless security settings under Device
5
Information and check if the WLAN connection is up under Interface Status.
Chapter 5 Tutorials
SSID_Example3
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
NBG-418N v2 User's Guide
48
Section 2.2 on page
17).
Advertisement
Table of Contents
